Network and Cybersecurity

UPS and Power Continuity for Camera Systems

Keeping cameras and recording running during a power outage has to be designed separately. We design UPS and power covering switches, recorders and critical cameras. Load and runtime calculation, generator transfer, surge protection, remote monitoring and battery tests are part of the design.

UPS sizingRuntime calculationPoE loadGenerator transferSurge protectionSNMP monitoringBattery testCritical camera priority

Service definition

What is UPS and power continuity for camera systems, and who is it for?

Power continuity in camera systems means camera, network and recording components keep running and aren’t damaged during power outages, fluctuations and surges. If a camera shuts down during an outage, there’s no recording of those minutes.

01

How many minutes should a UPS last?

If there’s a generator, long enough to comfortably cover the transfer time; if not, it’s calculated according to the outage scenario set by the organization.

02

Are cameras connected to UPS units one by one?

Usually not. PoE switches are connected to the UPS; cameras get power through the switch.

03

How long do batteries last?

It depends on usage and ambient temperature. They’re monitored with periodic tests, and batteries with reduced capacity are replaced.

Project stages

How do we proceed?

01 / STAGE

Analysis

Load and priority.

02 / STAGE

Design

UPS and protection.

03 / STAGE

Implementation

Installation and monitoring.

04 / STAGE

Test

Outage simulation.

Video Surveillance

Let’s not go blind when the power goes out

Let’s talk about your current setup and the problem you’re facing. We’ll clarify the scope and deliverables in a written proposal.