Cameras, Racks and Power · #76

Online CCTV Bandwidth Calculator

Calculates recording (into the NVR) and viewing (out to clients) traffic separately.

  • Data is processed in your browser and not sent to a server

Tool

name;count;main Mbit/s;sub Mbit/s

name;clients;concurrent streams;Mbit/s — optional.

For remote viewing; optional.

What does this tool do?

Camera networks carry two flows: the continuous recording stream from cameras to the NVR and live/playback streams pulled by clients. For remote viewing the bottleneck is usually WAN upload. The tool calculates both separately and gives utilization for the switch uplink and WAN.

How to use it

  1. Enter camera groups as name;count;main Mbit/s;sub Mbit/s; tick if the sub-stream is recorded too.
  2. Add viewing clients as name;clients;concurrent streams;stream Mbit/s.
  3. Enter uplink and WAN speeds and press Run.

Fields

Camera groups
name;count;main Mbit/s;sub Mbit/s
Sub-stream is recorded too
Viewing clients
name;clients;concurrent streams;Mbit/s — optional.
Recording uplink
From camera switch to NVR.
WAN upload
For remote viewing; optional.

Worked example

InputValue
Camera groups
Bina A;24;4;0.5
Bina B;16;6;0.7
Sub-stream is recorded too–
Viewing clients
Güvenlik odası;1;16;0.7
Mobil;3;4;0.5
Recording uplink1000
WAN upload50

Expected result: Recording 192 Mbit/s (19 % of a 1 Gbit/s uplink); viewing 17.2 Mbit/s, 34 % of a 50 Mbit/s WAN.

WAN is fine while the control room views 16 cameras on the sub-stream; viewing on the main stream (4–6 Mbit/s) would fill the WAN. Enable sub-stream and 'adaptive stream' settings in clients.

Second scenario

InputValue
Camera groups
PTZ;4;8;1
Sub-stream is recorded too✓
Recording uplink100

Expected result: 4 PTZ cameras, main 8 + sub 1 Mbit/s with sub-stream recorded: 36 Mbit/s, 36 % of a 100 Mbit/s uplink.

Method and assumptions

Recording = Σ cameras × (main [+ sub]). Viewing = Σ clients × concurrent streams × Mbit/s. Uplink utilization uses recording, WAN utilization uses viewing; above 70 % is amber.

Using the result and troubleshooting

Keep recording traffic below 70 % on Gigabit uplinks; otherwise distribute NVRs or use 10G. Continue to the CCTV Storage Calculator for disk.

Limits and common mistakes

  • Protocol overhead (RTP/RTSP ~5–10 %), multicast and VBR peaks are not modelled separately.

Frequently asked questions

How do I get Mbit/s from camera resolution?

Read the average bitrate in the camera UI. As a rough start with H.265 at 15 fps: 2 MP ≈ 2, 4 MP ≈ 4, 8 MP ≈ 8 Mbit/s; it varies with the scene.

Related tools and service

Related service: PoE Switches and Camera Network Infrastructure

CCTV online tools · See all online tools